AC CURRENT TRANSDUCER
		SELECTION GUIDE M100-AA1 1 ph. self powered ave. sensing RMS calibrated M100-AL1 1 ph. aux. powered ave. sensing RMS calibrated M100-AR1 1 ph. aux powered true RMS sensing RMS cal. M100-AA3 3 ph. self powered ave. sensing RMS calibrated M100-AL3 3 ph. aux powered ave. sensing RMS calibrated TYPICAL APPLICATIONS The M100 series current transducers are designed to measure A.C. Current in single and 3 phase systems. They convert the A.C. signal to a D.C. Output that is directly proportional to the input signal. The M100-AA1 AA3 are self powered (i.e. no auxiliary required) average sensing RMS calibrated current transducers, mA and voltage outputs are available. The M100-AL1 AL3 are average sensing RMS calibrated, live zero current transducers. Auxiliary is required to provide power, so that 4mA output signal is present, when the input is zero. The M100-AR1 is true RMS sensing RMS calibrated allowing measurement of distorted waveforms of up to 9th harmonic with a crest factor of 5. The AR1 is typically used in current measurement where distorted waveform is common, such as thyristor drives The above units are used to measure current in energy management systems, switchboards, generator and telemetery controls. Isolation of 4kV is provided between the input and output signal, allowing the output to be fed to conventional analogue meters, digital meters, PLC, and computer systems. ORDERING INFORMATION Product Code Input In Output Aux Freq. Options M100-AL1 5A 4-20mA 230V 50Hz OPTIONS 1. Non standard inputs / outputs only as far as technically acceptable. 2. A.C. Auxiliary in range 57.7 to 450 volts 3. Calibration at nominal Hz 35.....450Hz 4. Calibration at temperature other than 23°		TECHNICAL SPECIFICATION INPUT Rated value In 1 or 5 Amp C.T. connected 0.5-10 Amp direct connected Power consumption <1 VA (AA1, AA3) <0.2 VA (AL1, AL3, AR1) Working range 10-125% In (AA1, AA3) 0-125% In (AL1, AL3, AR1) Rated Frequency 50 / 60 / 400 Hz Frequency influence 0.005 % / Hz Overload continuous 4 x In Overload for 1 sec. 50 x In OUTPUT Rated value mA 0-1/5/10/20mA (AA1, AA3) Rated value mA 0-1/5/10/20 & 4-20mA (AR1) Rated value mA 4-20mA (AL1 AL3) Rated value volts 0-5 / 10 V (AA1 AA3) Rated value volts 0-5 / 10 & 1-5 V (AR1) Rated value volts 1-5 V (AL1 AL3) ADJUSTMENT Zero No adjustment (AA1 AA3) Zero ± 2% (AR1, AL1 AL3) Span ± 10% (AA1, AR1, AL1 AA3 AL3) AUXILIARY A.C. Voltage 115 / 230 / 400 V (± 25% / 45-65 Hz / < 2VA) D.C. Voltage 24 / 48 / 110 V (± 20% / galvanically isolated / <3 W) Note M100-AA1 AA3 are self powered WEIGHT & CASE M100-AA1 Approx. 0.3 kg. 55mm case M100-AL1,AR1 Approx. 0.4 kg. 55mm case M100-AA3 Approx. 0.6 kg. 100mm case M100-AL3 Approx. 0.7 kg. 100mm case