TRANSDUCER GENERAL SPECIFICATIONS

ENVIRONMENTAL
 Working temperature 0 to +60 deg C
 Functional temperature -25 to +70 deg C
 Storage temperature -55 to +85 deg C
 Temperature coefficient 0.02% per deg C (100 ppm / °C)
 Relative humidity 95% non condensing
 Class of climate HSE complying with DIN 40040
 -3 complying with VDE/VDI 3540

INSULATION
Test Voltage
4kV RMS 50Hz 1min. between
Input / Case / Auxiliary / Output
 Impulse test EMC 5kV transient complying
 with IEC 801 / EN55020
 HF interference test EHF 2.5kV 1MHz complying
 with IEC 255-4
 Protection class II complying with IEC 348
 BS 4753 / DIN 57411 / VDE 0411

APPLIED STANDARDS
 General IEC 688 / BS 6253 / VDE/ VDI 2192
 Safety BS EN61010
 DIN 57411 / VDE 0411
 ANSI C37
 Surge withstand IEC 801 / EN 55020
 ANSI C37-90a
 Radio screening RFI degree N complies with
 VDE 0875
 EMC Emissions EN50081-2
 Immunity EN50082-1

APPROVALS
 cU.L. Approval File No E157034

 

ACCURACY
 Class ±0.2 % complying with IEC 688
 Calibration temperature 23°C
 Temperature coefficient 0.01% / °C (100 ppm / °C)
 Stability 0.05 % per annum non cumulative
 Warm up time <15 min
OUTPUT
 Rated value See individual product pages.
 Load resistance
1mA <15 kOhm
 5mA <3 kOhm
 10mA <1.5 kOhm
 20mA < 0.75kOhm
 4-20mA < 0.75kOhm
 Load resistance volts 1, 5 & 10 volts >1 kOhm
 (M100-VA1,VA3 only) 1, 5 & 10 volts > 50kOhm
 Load influence <0.1 %
 Ripple <0.5% peak-peak at full load
 Response time <200 msec for 0-99 % at full load
 Overload <2 x rated value at full load
 No load voltage <27 V
ENCLOSURE
 Fixing Snap on to DIN rail 35 x 7.5 mm
 complies with DIN-EN 50022
 BS 5584
 Mounting Any position
 Enclosure Code Case IP 50 / terminals IP 30
 Complies with IEC 529
 BS 5490 DIN 40050