PHASE ANGLE TRANSDUCER
	SELECTION GUIDE M100-PA1 Single phase 4 quadrants M100-PA2 3 phase 3 or 4 wire balanced 2 quadrants M100-PA3 3 phase 3 or 4 wire balanced 4 quadrants M100-PV1 Single phase 4 quadrants phase angle between two voltages TYPICAL APPLICATIONS The M100-PA series of phase angle transducers measure the phase angle between current and voltage. They can be used on single and 3 phase 3 or 4 wire balanced systems. Ideal for optimising power factor correction. The M100-PV2 measures the phase angle between two voltage supplies and provides a D.C. Output signal proportional to the phase angle between the voltages. ORDERING INFORMATION Product code I/P In Un O/P Range Aux. Freq.Opt. M100-PA2 5Amp 400V ± 45° 120V 60Hz OPTIONS 1. Non standard inputs / outputs only as far as technically acceptable. 2. A.C. Auxiliary in range 57.7 to 450 volts 3. Calibration at nominal Hz 35.....450Hz 4. Calibration at temperature other than 23°C
		TECHNICAL SPECIFICATION INPUT Rated value In 1 or 5 Amp C.T. connected 0.5-10 Amp direct connected Rated value Un 57.8 < 600 volt Power consumption <1 VA voltage (aux powered) <2.5 VA voltage (self powered) <0.2 VA current Working range 15-125% Un auxiliary powered 75-125% Un self powered 10-150% In Measuring range ± 45 / 60 / 90 / 180° M100-PA1 ± 45 / 60° M100-PA2 ± 90 / 180° M100-PA3 Rated Frequency 50 / 60 / 400 Hz Frequency influence 0.005 % / Hz Overload continuous 4 x In 1.5 x Un Overload for 1 sec. 50 x In 2 x Un ACCURACY ± 1 Degree OUTPUT Rated value mA 0-1/5/10/20 & 4-20mA Rated Value Volts 0-5 / 10 & 1-5 V ADJUSTMENT Zero ± 2% Span ± 10% AUXILIARY A.C. Voltage 115 / 230 / 400 V (± 25% / 45-65 Hz / < 2VA) D.C. Voltage 24 / 48 / 110 V (± 20% galvanically isolated / <3W) WEIGHT & CASE SIZE Approx. 0.6 kg. 100mm case