The M801 and M802 are compact 96 x 96 mm Din cased, 3 phase power meters.

M802 and M801 measure Volts, Amps, Frequency, Active Power and Apparent Power.

The M802 also measures Reactive Power, Active Energy, Reactive Energy, Power Factor, Amp Demand, Apparent Power Demand, Active Power Demand, Maximum Amp Demand, Maximum Apparent Power Demand and Maximum Active Power Demand.

Voltage and current measurements are true RMS.

Product code:
M801-MD1 Single Phase
M801-MD4 3 Phase 3 wire unbalanced load
M801-MD9 3 Phase 4 wire unbalanced load

M802-MD1 Single Phase
M802-MD4 3 Phase 3 wire unbalanced load
M802-MD9 3 Phase 4 wire unbalanced load

The MultiDin is designed to be user friendly and simple to use. All operations, including programming are performed by using the two push buttons on the front of the instrument.
MultiDin units are pre-programmed by the factory and no further programming is necessary. However, a user can reprogram most parameters in a MultiDin e.g. nominal current and voltage inputs, relay output etc. The reprogramming operations are covered in the manual (see section 4).